GME and GMI Laboratory Test Procedures Body and Electric Collection
This collection contains documents from the following standards organization(s): General Motors Europe 1 2 3 4 > >
| GME GME L-0-1 | EN-Measurements on Vehicle Air Conditioning Systems in the OPEL Environment Tunnel-English/German | |
| GME GME L-0-11 | EN-Basic Test-English/German | |
| GME GME L-0-12 | EN-Friction Test-English/German | |
| GME GME L-0-13 | EN-High Frequency Test-English/German | |
| GME GME L-0-14 | EN-Test for Lag of Damping Force-English/German | |
| GME GME L-0-15 | EN-Low Temperature Test-English/German | |
| GME GME L-0-16 | EN-High Temperature Test-English/German | |
| GME GME L-0-19 | EN-Determination of Mass and Trim Heights-English/German | |
| GME GME L-0-2 | EN-Determination of the Center of a Vehicle-Englihs/German | |
| GME GME L-0-20 | EN-Temperature Test-English/German | |
| GME GME L-0-23 | EN-Calibration Procedure for Tooth Belt Tension Gauge-English | |
| GME GME L-0-24 | EN-Checklist for the Initial Inspection of Durability Test Vehicles-English/German | |
| GME GME L-0-3 | EN-Rotary Shaft Seal Durability Test-English/German; Includes Appendix A - E | |
| GME GME L-0-37 | EN-Test Procedure for Signal Generation and Execution of Simulated Durability Tests-English/German | |
| GME GME L-0-39 | EN-Functional Noise Measurement in Stationary Vehicles-English/German | |
| GME GME L-0-4 | EN-Single Step Test-English/German | |
| GME GME L-0-5 | EN-Dynamic Strength Test-English/German | |
| GME GME L-0-8 | EN-Stair-Case-Test to Dixon and Mood-English/German | |
| GME GME L-0-9 | EN-Test for Bolt Loosening-English/German | |
| GME GME L-1-1 | EN-Body Distortion-English/German | |
| GME GME L-1-10 | EN-Sound Deadening of Body-English/German | |
| GME GME L-1-19 | EN-Transverse Stiffness of Bonnet/Load Compartment Cover Hinge-English/German | |
| GME GME L-1-2 | EN-Body in White: Determination of Resonant Frequency-English/German | |
| GME GME L-1-3 | EN-Rollover Test-German | |
| GME GME L-12H-1 | EN-Ground Connections-English/German | |
| GME GME L-12L-2 | EN-Anti-theft Warning Device-English/German | |
| GME GME L-12L-3 | EN-Low Frequency Interferences over Vehicle Electrical System-English/German | |
| GME GME L-13A-1 | EN-Radiator Durability Test-English/German | |
| GME GME L-13D-1 | EN-Coolant Flow Through Heater Core in the Vehicle-English/German | |
| GME GME L-13D-2 | EN-Determination of Heater Core Characteristics-English/German | |
| GME GME L-1A-2 | EN-Attachments of the Shock Absorbers Underbody-English/German | |
| GME GME L-1A-3 | EN-Rear Axle to Body Attachment-English/German | |
| GME GME L-1A01-2 | EN-Front and Rear Tie Down Lugs-English/German | |
| GME GME L-1A02R-2 | EN-Side Air Bag Misuse Test Procedure for Side Impact Detection Systems Based on Acceleration Sensing-English/German | |
| GME GME L-1B03-1 | EN-Hood Hinges Wear Test-English/German | |
| GME GME L-1B04-1 | EN-Laminated Glass - Front Window Panes-English/German | |
| GME GME L-1B1201-1 | EN-Heating System Complete-English/German | |
| GME GME L-1B1201-10 | EN-Linearity Test at Passenger Vehicle Heating and A/CSystems on Heater Test Bench and in the Climatic Wind Tunnel-English/German; This standard may be applied only for current projects incl. Global Epsilon e (37##). It | |
| GME GME L-1B1201-11 | EN-Water Separation-English/German | |
| GME GME L-1B1201-12 | EN-Performance Measurements on AC-Systems in Passsenger Car-English/German | |
| GME GME L-1B1201-13 | EN-Dehumidifying Capability of Vehicle Air-Conditioning Units-English/German | |
| GME GME L-1B1201-14 | EN-Air-Side Characteristics of the Vehicle-English/German | |
| GME GME L-1B1201-2 | EN-Heater Cores-English/German | |
| GME GME L-1B1201-3 | EN-Subjective Evaluation of the Heating System During Warm-Up Phase Tunnel Test-English/German | |
| GME GME L-1B1201-4 | EN-Pressure Fatigue and Burst Test of EPDM Heater and Cooling Water Hoses-English/German | |
| GME GME L-1B1201-5 | EN-Heating System Maximum Capacity-English/German | |
| GME GME L-1B1201-6 | EN-Interior Windshield and Side Window Defrosting in a Passenger Car-English/German | |
| GME GME L-1B1201-8 | EN-Air-Side Characteristics of the A/C and Heater Module-English/German | |
| GME GME L-1B1201-9 | EN-Windshield Defrosting System Performance Validation for Passenger Vehicles-Revision 2; English/German | |
| GME GME L-1B1203-1 | EN-Durability Test Sunvisor-English/German | |
| GME GME L-1B1205-2 | EN-Windshield Wiper Motor Test-English/German | |
| GME GME L-1C-1 | EN-Roof Crush Resistance-English/German | |
| GME GME L-1C-2 | EN-Roof Water Drainage-English/German | |
| GME GME L-1C/D/E/F/G/H/01-6 | EN-Buckling Resistance of the Body-English/German; Includes Appendix A - D | |
| GME GME L-1C1211-1 | EN-Durability Test of Assist Handles-English/German | |
| GME GME L-1E01-1 | EN-Rear Compartment Lid Test-English/German | |
| GME GME L-1E01-2 | EN-Fuel Filler Lid-English/German | |
| GME GME L-1E01-3 | EN-Measurement of Torsional Stiffness of Hoods Tailgates and Trunk Lids-English/German | |
| GME GME L-1E01-4 | EN-Trunk Lid-Burglar Alarm/Theft Protection-English/German | |
| GME GME L-1E01-5 | EN-Trunk Lid Closing Behaviour-English/German | |
| GME GME L-1E06-1 | EN-Misuse Test of Load Compartment Cover in the Estate-English/German; This standard may be applied only for current projects incl. Global Epsilon e (37##). It is Superceded for all future projects and replaced by GMW14 | |
| GME GME L-1F/G-1 | EN-Measurement of Frame Stiffness of Front and Rear Doors-English/German | |
| GME GME L-1F/G01-2 | EN-Strain Test of the Door Hinge Location Front and Rear Door-English/German | |
| GME GME L-1F/G01-4 | EN-Door - Tensional Test-English/German | |
| GME GME L-1F/G01-5 | EN-Door Strength Test-English/German | |
| GME GME L-1F/G01-6 | EN-Door Stop - Function and Noise-English/German; This standard may be applied only for current projects incl. Global Epsilon e (37##). It is Superceded for all future projects and replaced by GMW14803 | |
| GME GME L-1F/G02-1 | EN-Door Closing-Noise Comfort-English/German | |
| GME GME L-1F/G03-1 | EN-Door Test under Field Conditions-English/German; This standard may be applied only for current projects incl. Global Epsilon e (37##). It is Superceded for all future projects and replaced by GMW15094. | |
| GME GME L-1F/G03-10 | EN-Door Lock Remote Control Wear Test-English/German | |
| GME GME L-1F/G03-11 | EN-Door Locks (not installed) Freeze Test-English/German | |
| GME GME L-1F/G03-19 | EN-Fatigue Test of Door Look Strikers-English/German | |
| GME GME L-1F/G03-2 | EN-Pulling of Doors Beyond Stop-English/German | |
| GME GME L-1F/G03-20 | EN-Functional and Durability Test of Outside Door Handle Flap Version-English/German | |
| GME GME L-1F/G03-3 | EN-Manual Operated Window Lifter-English/German | |
| GME GME L-1F/G03-4 | EN-Window Regulator Static Test-English/German | |
| GME GME L-1F/G03-6 | EN-Power Window Lifter-German | |
| GME GME L-1F/G03-9 | EN-Lock Cylinder and Inside Door Look- Fatigue Test-English/German | |
| GME GME L-1F/G04-1 | EN-Window Mounting Rail Pull Test-English/German | |
| GME GME L-1F/G06-1 | EN-Door Arm Rest - Static Load-English/German |
1 2 3 4 > >